G'day Kristin,

It's a single wall set and needs to be attached in one go.  The zips between each section allows you to unzip to a certain point, and either roll up the unwanted panels, or peg and pole them out as awning extensions.

G'day Danika,

The walls are designed to work best with awnings that are mounted at around 1.9-2m off the ground. You could use these walls when mounted to a lower vehicle, but you'll just have to set up the walls at a wider angle. It won't be ideal, but should still work ok.

G'day Mitch,

Yes, the 3 walls are:
1 x single wall pannel across the whole front of the awning
2 x rear awning panels

G'day Rob,

Yes, they are.  Whilst this particular awning can be used on the side of a vehicle as well, it was primarily designed as a rear vehicle awning, so the wall set reflects this.

G'day Rachel,

It took me a little while to work out exactly what you meant, but I think I understand. The walls taper out so create more space at the ground level. Darche doesn't give an exact figure, however, my best estimate is about an extra 50cm of width between where the poles would normally sit, and where they'll sit once angled with the tapered walls. Did you want us to give Darche a call and double-check if they have an exact figure? If so, just send us a quick email and we'll follow it up for you.

G'day Peter, 

This set is designed to attach to the Darche Eclipse 180 Versatile Awning which attaches to the rear or side of your vehicle and provides 4m² of coverage. The Darche Eclipse 180 Awning Wall set is designed to attach to the Darche Eclipse 180 Awning which attaches to the passenger side of your vehicle and has 8.2m² of coverage.